To purchase Starlink Mesh for your home network, log into your account and visit the Starlink shop.

In some homes, a single WiFi router may not provide enough wireless coverage, leading to poor performance in certain areas. A Starlink Mesh network extends coverage by placing Starlink Mesh routers between your main router and areas with weak signals. For the best performance, place Starlink Mesh routers 1–2 rooms apart from the primary router.

We do not recommend using more than three Starlink Mesh routers. If your home is larger than 6,000 square feet, Starlink Mesh may not provide full coverage, and you may want to consider a third-party mesh system.

​

Important Notes:

• Starlink mesh routers can be purchased to replace a damaged router of the same type.
• The Gen 3 router is currently only available on the Starlink shop in select markets.
• Gen 1 routers do not support mesh.

​

---

Gen 3 Router

Specifications

• IEEE 802.11a/b/g/n/ac/ax standards
• Tri-band 2.4GHz and 5GHz
• 4x4, MU-MIMO, OFDMA
• WPA2 security
• Operating Temperature: -22°F to +122°F (-30°C to +50°C)
• IP56 rated (water resistant)
• Gen 3 Router - Setup Guide

Compatibility

• Gen 3 can be used as a main router or a mesh node for only Gen 2 and Gen 3 Starlink routers. To use the Gen 3 router as the main router for the Standard Actuated Starlink, connect it to the Gen 2 router using an ethernet adapter and set the Gen 2 router to bypass mode.
• Gen 3 Router Setup Guide (Standard Actuated).

​

Gen 2 Router

Specifications

• IEEE 802.11a/b/g/n/ac standards
• Dual band 2.4GHz and 5GHz
• 3x3 MIMO
• WPA2 security
• Operating Temperature: -22°F to +122°F (-30°C to +50°C)
• IP54 rated (water resistant), configured for indoor use
• Gen 2 Router - Setup Guide

Compatibility

• The Starlink Mesh WiFi Router cannot be used to form a mesh network with the Gen 1 or any third-party modems, routers, or mesh nodes.
• The Starlink mesh WiFi router is compatible with Gen 2 and Gen 3 router.
• You can use a Starlink ethernet adapter to connect other devices to the Starlink mesh WiFi router.
  • If the Gen 2 is the main router and the Gen 3 is the mesh node, you can create a wired mesh network by connecting the Starlink ethernet adapter on the Gen 2 to the WAN port on the left side of the Gen 3 router using an ethernet cable.